HDMI Extender, AGPtek LKV373 100M over Ethernet Network Routers/Switchers LAN RJ45 CAT5 CAT6-Single Source from 1080P Full HD STB,DVD,PS3 – w/DLP,LCD,LED ,Supports TCP/IP by Ethernet – Cheap Price

HDMI Extender, AGPtek LKV373 100M over Ethernet Network Routers/Switchers LAN RJ45 CAT5 CAT6-Single Source from 1080P Full HD STB,DVD,PS3 - w/DLP,LCD,LED ,Supports TCP/IP by Ethernet
This LKV373 HDMI extender and receiver set is designed to convert HDMI signal to standard TCP/IP and transmit by CAT5e/6 Cable or LAN.With the advantage of TCP/IP standard, it can transmit HDMI signal source from HD STB,DVD,PS3,HDMI display card etc to HD projector, DLP,LCD,LED and other audio visual equipments.

Extends by Router connection or LAN connection ,Cable length requirements are as follows:
CAT5 Maximum 80 meters between two Devices
CAT5e Maximum 100 meters between two Devices
CAT6 Maximum 120 meters between two Devices

Specification:
Supports resolutions: [email protected],[email protected],[email protected], [email protected],[email protected]/60Hz,[email protected]/60Hz, [email protected]/60Hz Working Temperature: -10¡æ ~60 ¡æ
Link Connector(Sender/Receiver): UTP/STP CAT5e/6
Power Consumption: 3W (max) each
Relative Humidity: 20%~90%
Power Supply: DC 5V/1A
Dimensions: 110 x 58 x 26 mm
Weight: 239 g
Cat5e/6 cable: Follow the standard of IEEE-568B

Package Included:
1 x HDMI Extender Sender
1 x HDMI Extender Receiver
2 x power supplier
1 x User manual

shopBlogs Bargain Buys

More Promoted: Sale Bargains

You may also like...

2 Responses

  1. Name Withheld says:

    5 Out of 5 Star Rating

    AGPtEK LKV372PRO HDMI Network Extender w/ Loop-Out 196ft/60m Over Cat6/6a/7 Single cable for Local Display Monitor – Supports IR Signal Transmission – 2 HDMI Outputs (Accessory)

    I initially installed these unit on a 3 metre CAT 5 patch lead to test the units. At first I had a few issues getting the units to display video reliably but after pressing the reset button on the transmit and receiving unit a couple of times every thing was fine. I then ran just under 50m of CAT 5 screened cable and 50m of CAT 6 screened cable from my sky box to the TV in my office. I connected the CAT 5 screened cable expecting the units not to work as the cable was not to specification but it worked perfectly. The unit has been working on the CAT 5 cable for two days now with a perfect picture and IR remote operation. Still haven’t tested the units on the CAT 6 cable but I would expect it to work. If you are going to use CAT 6 cable be forewarned that the connectors are not the same as the CAT 5 connectors as the conductors are of a heavier gauge of wire.
    UPDATE-Tested on 50m CAT 6 cable with Sky box, worked well. Tested CAT 6 cable again but with a 1080i and 1080p signal from a WD media player, neither worked but the 720 mode worker fine. The Sky box worked in 720 and 1080i modes not sure why either is a discrepancy.

  2. Vikash says:

    3 Out of 5 Star Rating

    AGPtEK Ultra HD 4K*2K 3D HDBaseT HDMI Network Extender w/ Bi-directional IR Remote, 70m over Single CAT5E/6/7 Cable Supports 1080P Deep Colour (Electronics)

    The product seems to be working at the moment. My only reservation at the moment is when you touch either of the two boxes, they are always running quite hot. I am hoping this doesn’t cause a problem in the long run and reduce the lifespan of the item.

    You would hope that there was some ‘standby mode’ for when there is no signal being detected. Also the added benefit for this would be the energy saving!

    If this product is still up and running in the 3-4 months or so, I’ll probably bump it to a 4 star.

Leave a Reply

Your e-mail address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Powered by WP Robot