• Uncategorised

GEEETECH Stepper Motor EasyDriver Shield Drive Driver Board – Cut Rate

GEEETECH Stepper Motor EasyDriver Shield Drive Driver Board
Product Info:
The EasyDriver is a simple to use stepper motor driver, compatible with anything that can output a digital 0 to 5V pulse
(or 0 to 3.3V pulse if you solder SJ2 closed on the EasyDriver).
It requires a 7V to 30V supply to power the motor and can power any voltage of stepper motor.
It provides much more flexibility and control over your stepper motor, when compared to older versions.
The microstep select (MS1 and MS2) pins of the A3967 are broken out allowing adjustments to the microstepping resolution.

Features:
?Compatible with 4, 6, and 8 wire stepper motors of any voltage
?Adjustable current control from 150mA/phase to 750mA/phase
?MS1 and MS2 pins broken out to change microstepping resolution to full, half, quarter and eighth steps (defaults to eighth)
?Power supply range from 7V to 30V. The higher the voltage, the higher the torque at high speeds
Note: Do not connect or disconnect a motor while the driver is energized. This will cause permanent damage to the A3967 IC.

Note: This product is a collaboration with Brian Schmalz.
A portion of each sales goes back to them for product support and continued development.

Package list:1x Board

https://couponmatrix.uk/posts/wp-content/uploads/2018/04/41r4h7L2ukL._SL160_.jpg

  • The EasyDriver is a simple to use stepper motor driver, compatible with anything that can output a digital 0 to 5V pulse
  • (or 0 to 3.3V pulse if you solder SJ2 closed on the EasyDriver).
  • It requires a 7V to 30V supply to power the motor and can power any voltage of stepper motor.
  • It provides much more flexibility and control over your stepper motor, when compared to older versions.
shopBlogs Bargain Buys

Related Items: Sale Products

You may also like...

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.