Car Aircon Air Con Air Conditioning Gas Top up Recharge

Car Aircon Air Con Air Conditioning Gas Top up Recharge Refill Regas Tool Ki

Complete ready to use kit. Compatible with R134a systems (most cars upto 2016, most commercials upto 2021.) Incredible performance – stops leaks & makes warm vehicles ice cold. Refill your vehicle AC and get peak performance back. R134a Equivalent does NOT contain HFC’s (Hydroflurocarbons.) Check under bonnet or in car manual to see if your vehicle is R134a or R1234yf, and that you can identify the low side filling port before purchase. Wear safety goggles and gloves when working on AC systems. Never wear loose clothing around running engines. Tested for use in automotive systems only. Do not vacuum AC system before use. Propellant – This AC topup system has been developed and refined by us over a more than ten year period to be a fast and inexpensive way to recharge your AC system. The product is hydrocarbon based and so is able to dissipate more heat, meaning colder AC for better driver comfort. Use the manifold and gauge to deploy enough product into the vehicle to fill to the specified level to restore peak AC performance. Hose – This professional manifold is designed for Aircontopup self-piercing cans. Has an extended hose making it easier to reach difficult low pressure coupling locations whilst enabling the gauge to be read. Features a special connector which allows one handed connection to the car – great for tight installations. Top quality brass fittings and pressure gauge with rubber impact protection surround. Leak Sealer / Propellant – Ageing causes coolant pressure loss. This product is specially formulated to recondition shrunken seals and can help to restore system integrity. Deploy the contents of the can into a low or empty system using the manifold and check to make sure the compressor kicks in and out. Use the gauge to check pressure achieved and allow that to sit over an extended period. If the pressure holds you have repaired the leak and you can then use additional Aircontopup propellant to charge to the correct pressure. If the system does not hold pressure then you have diagnosed a more serious mechanical leak for the cost of the can, rather than garage labour. Also since our leak stopper contains a small amount of propellant it can be used to perk up and condition systems with slightly low levels but that do not require a full regas.

• Made In The USA. Accept no substitite – Aircontopup is the original and best DIY recharge system. Completely safe to mix and fully compatible with original refrigerant. Supplied with instructions. You Receive: 1x168g Refill equivalent to 453g of R134a + 1x112g Leak Sealer equivalent to 300g of R134a + 1xProfessional Type Hose & Gauge (R134a) + Instruction Sheet
• Cans have 1/2 inch coarse right hand ACME thread and work perfectly with the supplied Aircontopup hose. Engine & AC compressor must be running & switched on before attempting to add product. Once can is attached to a hose it must not be detached until empty, as it will not self seal and may still have pressure in it. Returns not accepted on deployed/pierced
• Suits competent DIY – read instructions before use and contact us for help if in doubt. Ozone friendly – does not infringe UK regulations and F Gas license is NOT required. Our cans are sized for an average car depleted of coolant to a typical level. Some vehicles with very large systems may require more than one can. Refer to vehicle data or use gauge or weights to ensure correct fill.
• Some French vehicles may require an additional adaptor if they do not have the standard R134a fitting. Do not try to force this hose on to an R1234yf fitting. Suitable for R134a only. Note that gauge needle does not zero after use. Reading valid whilst under pressure only. Professional quality gauge and hose with long extension is reusable as required.
• LEAKSTOPPER Repairs most leaks caused by inefficient seals – It will not repair large breaches in the integrity of a system.